PDA

View Full Version : Greddy E-01 Boost Settings


alonroz
05-25-2007, 06:18 AM
Hi,
my vehicle is pretty much stock 96 silvia s14...
Z32 MAF, Apexi indution pipe and filter, 3" catback exuahst, stock smic,
XS power exuahst manifold, NGK Iridium plugs.
what kind of boost figures should i run on my profec E-01?
i was thinking about low-10psi,high (will almost never be used)-14psi.over take at 17psi(?).
does that sound good? or is it too much?
can anyone tell me the best settings (gain,set,strat etc...)?
i would rather have quick spool up than more power...
thanks in advance,
Alon

slider2828
05-25-2007, 11:40 AM
Too bad this turbo doesn't get enough light because people think it is complicated. I would really suggest you upgrade the firmware first at mohdparts.com. THen you can based boost level off speed. Then I would probably do the automatic instead of the manual boost settings. That will set the gain and set. THe start boost should be 2.3 under the targeted psi.

Finally do a search, I did a write up before.

alonroz
05-25-2007, 03:22 PM
Too bad this turbo doesn't get enough light because people think it is complicated. I would really suggest you upgrade the firmware first at mohdparts.com. THen you can based boost level off speed. Then I would probably do the automatic instead of the manual boost settings. That will set the gain and set. THe start boost should be 2.3 under the targeted psi.

Finally do a search, I did a write up before.
is the firmware update safe? what does it update in the profec's software?
will do an auto boost setting! do my boost figures sound ok?
searched and didn't find any write up's...:confused:

slider2828
05-25-2007, 03:39 PM
Searched and found (http://www.zilvia.net/f/showthread.php?t=105737&highlight=profec+e01)

Dude I just did a search and found my right up.

Yes the update is 100% safe.

Secondly, it should do automatic. Read the E01 manual. It tells you exactly how to set it in automatic and you can download it on greddy's site.

slider2828
05-25-2007, 03:40 PM
You wanna blow something with those settings. you should do off, then 10 for low, 12 for high and overboost at 14. But since you are stock 14 psi means you are almost at 100% of your injectors and 90% efficiency on your turbo.

alonroz
05-26-2007, 05:43 AM
thanks allot!
last small thing,
my start boost should be 2~2.3 psi lower than my targeted low boost or high boost?
Alon