Bride Bucket seat center alignment

[boozels]

Anybody have a problem with the bucket seat being mis-aligned after the install?
My seat is a little to the left of the center of the steering wheel.
I was wondering if anyone else had this problem
tryin to fix it without welding up new tabs

http://i89.photobucket.com/albums/k207/boozels/IMG_1345.jpg

I have a Bride Zeta III with Nagisa double lock rails on a s13 fyi
Thanks

[AJ1356]

try adjusting from the seat mounts and rails , this usually happens you just need to use abit ingenuity to move it to eaither side.

[trybal]

looks like your seat is butted against the center column.. doesn't seem like you could more it anymore right

[yudalicious]

I have the same problem with Sparco Evo on Bride rails. You should be able to wiggle the seat a bit more to the right where the brackets mount to the floor, and also by where the brackets mount to the seat. For me, the seat base was wide enough that it takes all the side to side adjustment out of the brackets, so now I'm used to sitting an inch to the left.

Anybody have a problem with the bucket seat being mis-aligned after the install?
My seat is a little to the left of the center of the steering wheel.
I was wondering if anyone else had this problem
tryin to fix it without welding up new tabs

http://i89.photobucket.com/albums/k207/boozels/IMG_1345.jpg

I have a Bride Zeta III with Nagisa double lock rails on a s13 fyi
Thanks

[boozels]

looks like your seat is butted against the center column.. doesn't seem like you could more it anymore right

I still have more room for the seat to move to the right but no more room to adjust the tabs

http://i89.photobucket.com/albums/k207/boozels/IMG_1346.jpg

[Slidin240Wayz]

Would it be possible to flip the brackets?

Carlos

[boozels]

Would it be possible to flip the brackets?

Carlos

I cannot flip the brackets b/c I would need to raise the seat up a few inches so the bottom of the seat clears the bottom of the bracket

[AJ1356]

is there any way to mount the bracket in a different location on the seat?

[Jon Michael]

Is there a way to put the right tab on so it's flipped, and facing the other way? Becuase, the left tab should have more room to move to the right, if it's just the right tab...

[woodchuck]

I cannot flip the brackets b/c I would need to raise the seat up a few inches so the bottom of the seat clears the bottom of the bracket

my old zeta 3 never did that cause i used a Bride FG rail.

from you pics it looks like you'll be able to flip the brackets and use different/flush hardware so you won't have to raise it up.

good luck - looks like you have to really macgyver it if flipping the bracket doesn't work.

[brokeAs240sx]

Are you able to raise the seat any more or you already getting too close to the roof? If you raise the seat to the middle or top notch, you can install the brackets reversed first, then install the seat onto the bracket.

Or possibly if you get nagisa single lock rails? Of course, you could also get bride fg rails and that may fix the problem...

I installed a different seat (buddy club wide) w/ bride fg rails, sat a lil off to the left, put it in w/ the nagisa single lock rails = much less off.