Andrew Bohan
04-13-2007, 05:36 PM
customer brought us this 240Z with a 327 small block in it. it also has coilovers and a Z32 diff and Q45 rear axles.
http://www.sdp-online.com/dats2.jpg
he wanted us to build a quiet dual exhaust for it, but there was no room for a pipe on the right side because of the gas tank.
we told him that, and he was sad, but we went ahead and built a quiet single exhaust.
but he really really wanted dual, so we replaced the back floor and installed a fuel cell to make room for the right pipe.
http://www.sdp-online.com/dats3.jpg
but then he didn't like how the quiet mufflers looked, so we replaced those with straight through magnaflows. now it's louder and looks better.
http://www.sdp-online.com/dats4.jpg
then he wanted the wiring made better looking. we started that job but found out most of the wiring was garbage, so we got a painless kit and rewired the whole car.
then he wanted autometer gauges installed, so we did that.
while we were in there, he wanted us to cover up the giant hole in the tranny tunnel that whoever put the motor in made. the 4-speed tranny is a side loader so the shifter is about 4" left of centerl
http://www.sdp-online.com/dats1.jpg
yeaa
http://www.sdp-online.com/dats5.jpg
http://www.sdp-online.com/dats6.jpg
http://www.sdp-online.com/dats2.jpg
he wanted us to build a quiet dual exhaust for it, but there was no room for a pipe on the right side because of the gas tank.
we told him that, and he was sad, but we went ahead and built a quiet single exhaust.
but he really really wanted dual, so we replaced the back floor and installed a fuel cell to make room for the right pipe.
http://www.sdp-online.com/dats3.jpg
but then he didn't like how the quiet mufflers looked, so we replaced those with straight through magnaflows. now it's louder and looks better.
http://www.sdp-online.com/dats4.jpg
then he wanted the wiring made better looking. we started that job but found out most of the wiring was garbage, so we got a painless kit and rewired the whole car.
then he wanted autometer gauges installed, so we did that.
while we were in there, he wanted us to cover up the giant hole in the tranny tunnel that whoever put the motor in made. the 4-speed tranny is a side loader so the shifter is about 4" left of centerl
http://www.sdp-online.com/dats1.jpg
yeaa
http://www.sdp-online.com/dats5.jpg
http://www.sdp-online.com/dats6.jpg