please help me id this plug!

[sbanzer123]

trying to get my s14 sr running in my sr and i cannot figure out where this plug goes. any ideas? it comes off the engine harness.

http://img.photobucket.com/albums/v313/Maxxman/DSC01327.jpg
http://img.photobucket.com/albums/v313/Maxxman/DSC01328.jpg

and btw its got spark, got fuel and cranks but no start. pretty sure timing is right. i pulled the motor out of a clip and havent touched the timing scince.

[AJ1356]

check out the pic in the link it connectes to the box shown in the picure, follow the other pics to help you out with most of the other connections. also did you do a 5 speed swap?

http://www.flickr.com/photos/[email protected]/422308923/

[sean350z]

AJ is right...

Though it's not going to solve your starting problem :ugh:

[projectRDM]

Wiper amplifier as mentioned for those who can't link out.

[sbanzer123]

yes that was it. thank you. no i didnt do a 5 speed swap. but my wipers will only work on high still with that plugged in. also i went outside. checked all grounds, got spark on all cylinders, got fuel, ecu was tightened down all the way, the plugs were black and wet like the motor was flodded i put a lighter to them to burn off the fuel. cranked it over but still nothing. i have no idea what the problem could be. any suggestions?

[sbanzer123]

fuel lines were on backwards! switched em and she started right up!! but i have it just with the air intake on the intake mani and the turbo open and when it sits there i kinda hear like a dinging noise from the turbo. i took the elbo off and there wasnt any gouges in the wheel or whatever you want to call it. and it had very minimal shaft play. could this just be because i have no intercooler piping on it and the intercooler piping usually muffles the noise. i hope my turbo isnt shot

[AJ1356]

good to hear it all worked out for ya :)