How do you remove gas pedal?

[srJOEYdet]

When I bought my car, it came with a pedal set... Two were installed proporly, and he gas pedal was wire-tied on. How do I removet the gas pedal on a 5 speed S13? I took a mirror and a flashlight, but couldn't make too much sense out of it all.


Joey

[240 2NR]

I'd like to know too.  I know people have used aftermarket pedals on S14's with success.  Do they have a pivoting gas pedal as well?  I have a pedal set I'd like to install but am debating between:
1.  cheating the brake over .5", and just installing the brake and clutch and leaving the gas pedal stock.

2.  doing the brake and clutch and getting a clip on gas pedal with a flare for heel and toe downshifting

3.  figuring out how to do it properly if someone can answer this question.

[uiuc240]

</span><table border="0" align="center" width="95%" cellpadding="3" cellspacing="1"><tr><td>Quote (240 2NR @ July 31 2002,11:54)</td></tr><tr><td id="QUOTE">I'd like to know too. I know people have used aftermarket pedals on S14's with success. Do they have a pivoting gas pedal as well? I have a pedal set I'd like to install but am debating between:
1. cheating the brake over .5", and just installing the brake and clutch and leaving the gas pedal stock.

2. doing the brake and clutch and getting a clip on gas pedal with a flare for heel and toe downshifting

3. figuring out how to do it properly if someone can answer this question.</td></tr></table><span id='postcolor'>
Steve, WTF are you talking about? &nbsp;Pivoting gas pedal? &nbsp;You mean how once it touches the floor it rotates back further? &nbsp;Almost all cars do that...what's the problem? &nbsp;Just install them like everyone else does and rock it.

Eric

[240 2NR]

Have you looked? It attaches to a rod that hangs down from above which is pivoted, and then the pedal is spring loaded on that. How do you srew a pedal into it's support? The best I can come up with is to attach it directly to the existing pedal.


How does everyone else do it?

[uiuc240]

</span><table border="0" align="center" width="95%" cellpadding="3" cellspacing="1"><tr><td>Quote (240 2NR @ July 31 2002,1:56)</td></tr><tr><td id="QUOTE">Have you looked? It attaches to a rod that hangs down from above which is pivoted, and then the pedal is spring loaded on that. How do you srew a pedal into it's support? The best I can come up with is to attach it directly to the existing pedal.


How does everyone else do it?</td></tr></table><span id='postcolor'>
yeah, they are just pedal covers. &nbsp;just screw it in like that.

Eric

[srJOEYdet]

hmmmm. Ok

[srJOEYdet]

hmmmm. Ok. thanks. oops i hit the button that first time. Sorry about the postwhoring