PDA

View Full Version : s14 wont start


stricnynel0s
02-18-2007, 05:16 PM
ok my s14 refuses to start because i have no spark, i had spark then one night i was driving car cut out and nvr started again, i checked all fuses, i got fuel, i changed plugs, rotor, and cap but nothing ne suggestions ? wont even go on a push start

[HK]240sx
02-18-2007, 09:59 PM
Battery, or alternator. Check your battery, make sure it's not dead, and check that the battery cables are okay.

As for alternator, you could have a dead alternator. If it's not the alternator itself, check the alternator belt. Make sure the belt has good tension.

stricnynel0s
02-18-2007, 10:54 PM
nah i know its none of those, battery is ok, i am leaing towards distro or timing

krazyfil
02-18-2007, 11:06 PM
what about starter??

sailainn
02-18-2007, 11:17 PM
ECU? any of the wires?.....bc it happened to me b4...one of the harness clips was loosse and I had no spark and couldent find out wtf it was till like 3 weeks later it was just a loose connection

krazyfil
02-18-2007, 11:19 PM
its it just making a clicking noise and not turning over... or is it just dead silence when u turn the key?

!Zar!
02-18-2007, 11:22 PM
It's not his starter guys...

You are describing the signs of a distributor/magneto/ignition coil problem.

Take your distributor to a shop where they can check it or check it yourself.

FusionR240sx
02-19-2007, 02:20 PM
same thing with me, but my car will start if i give it gas while starting it, but after it starts it will just die out unless i keep giving it gas.

stricnynel0s
02-19-2007, 02:49 PM
freakin KA is a peice i wanna get it starteds to just bloow it up now !!! j/k but this is very aggravating cuz i need 2 clean up my garage

!Zar!
02-19-2007, 03:18 PM
Did you completely disregard my post? The problem isn't the ka, it's you. All motors will have problems. If not distributor problems, coilpack problems.

FusionR240sx: Your problem is different from the OP.

stricnynel0s
02-19-2007, 05:36 PM
i am just fustrated about this motor cuz i only need it running for a week or so

stricnynel0s
02-19-2007, 08:32 PM
here it goes ladies and getlemen these codes are from a s14 auto convert to manual


p0443*
p1320
p0505*
p0110
p0325
p1441
p0335
p1605*
p0500
p0135
p0446
p0125
p1400
p1105

all of those reoccured immediately once i cleared the codes now the real mystery is which causes NO SPARK !!

!Zar!
02-19-2007, 10:21 PM
P0443 - EVAP Canister Purge Control Solenoid Valve

P1320 - Ignition Signal

P0505 - IACV-AAC Valve

P0110 - IAT Sensor

P0325 - Knock Sensor

P1441 - This one isn't a code to my knowledge. Are you sure it isn't P1401 ? which is the Temperature Sensor...

P0335 - CKP Sensor

P1605 - A/T Diagnosis Communication Line

P0500 - VSS

P0135 - Front HO2S Heater RH Bank

P0446 - You might have misred it for P0443 - EVAP Canister Purge Control Solenoid Valve or P1336 - CKP Sensor

P0125 - ECT Sensor

P1400 - EGRC Solenoid Valve

P1105 - I have no idea. It's almost P1150 - Wastegate Valve Control Solenoid Valve

Damn, I'm nice... And your car has HELLA problem.

shayrgob240
02-19-2007, 10:39 PM
out of all those P1320 stands out like a sore thumb. That is the only one that would cause your car to not start. Check the distributor....I'm tempted to say that your problem lies there. IF you have a spare, but it in (look in FSM for proper installation procedure). let us know what happens.

stricnynel0s
02-20-2007, 05:29 AM
im looking at 1320 also a friend is coming by with a distro tonight