FS: SOHC Crwr titanuim rods, wsco pistons, PnP head ka24e

[Import_Prophetz]

(USED 2 months) Crower Titanuim Rods w/ Wesico Pistons 10.5.1 .20 over bored with Re-sleeved Block and .20 overbored for only $650 --SOLD

(USED 2 months) Built Head with Camshaft (280lift, 480duration) Port and polish stage 2 and 3 angle valve job, with stainless steel valves for $550 --SOLD

(NEW) Findanza Flywheel $250

(new) Copper Head Gasket $50

Starter $50 worked when it was in car
Alternater $50 worked when it was in car

UD lighwieght pulley $50

Nismo Motor/Tranny Mounts Motor mount has poly urathane filling (semi-solid) $140
ARP Head Studs SOHC $150

ARP HEAD STUDS (NOT BOLTS), this will make sure your head wont lift from your block, under boost.

Anyother parts please contact me at [email protected]

[Import_Prophetz]

Rods/pistons are pending payment!

[Import_Prophetz]

some of these parts are rare, so KA24E single slammers should jump on this. You cant find better deals

[Import_Prophetz]

nobody in the zilvia.net forum needs sohc parts!

[Gilboyto]

I would take your pistons if they werent such a high compression

[Import_Prophetz]

Sold already, but to run 20psi, your not going to need low compression. it depends on your whole setup personally, i ran 10.5.1 compression on a 300zx Z32 TT on 20psi and dyno close to 700whp, but blew because i screw got sucked into the pop charger