do low seat rails work with different seats?

[niSm095]

do Nagisa low seat rails work with corbeau seats or are they only compatable with Bride seats? If they only work with Bride seats, are there any other low rails out there that work with different seats?

[slideways14]

they should be compatable with most side mount seats

[niSm095]

I haven't found any info saying corbeaus use side mounted rails, then again I haven't looked too incredibly hard, do they?

[ThatGuy]

Depends on the seat. God, are you really that friggin lazy that you can't even look at the Corbeau website? Here...
http://www.corbeau.com/prod_index/prod_index.shtml
Hey, look at at that. They sell Bottom and Side mount brackets for their seats. AMAZING!
Fixed back = Sidemount and Reclining = bottom mount just in case it would take too much effort on your part to figure it out.

Try not to be so lazy.

[johngriff]

Yeah you should know what type of rail if you are using that seat.

Bottom mount? For the loose man. We are lucky that we are right around the corner from wedge engineering, so we get sfi spec seat mounts, and installs for our 6foot + big asses (steve, luke, brain, nathan and I are all over 6 ft tall).

Lots of hammering, cutting involved in lowering that bottom mount seat, I still cant sit in lukes w/my helmet on.

Side mounts will DROP the seat alot, you might have better luck here.

[jmauld]

Fixed back = Sidemount and Reclining = bottom mount just in case it would take too much effort on your part to figure it out.

Try not to be so lazy.


My fixed back Forza's were bottom mount.

[ThatGuy]

Fair enough jmauld. I just glanced at the page to be honest. But at least I looked at the manufacturers page!

[niSm095]

jesus give me a break...I did look there but I wasn't looking at the corbeau brackets so I didn't look through what they offer. I was looking at their seats

[FaLKoN240]

I'm not gonna flame, but basically, only side mount seats can be used with sidemounts seats. Bottom mount seats can only be used with bottom mount seats.

Triangle peg only fits in the triangle shaped hole. You can't put the star shape in the triangle hole, UNLESS you do some major fabrication. Same rule applies. Look at pics of the seats, look where the seat bracket's mounts are. DONE.

RECLINABLE seats are usually BOTTOM MOUNT.

NON-reclinable are usually bottom mount.

[Rod]

I have a set of Corbau set rails if your interested. Their in almost new condition. But to answer your questions, I have Corabau A4's and used the Bride Super Low seat rails. Do not use the Nagisha or the Bride rails destined for buckets because they will not work! The Bride Super Low fits with minor modification.. Hope it helps! If you want my Corbau rails, send me a pm!

Rod