PDA

View Full Version : S13 Motor To S14 Motor


X 350GT X
12-31-2006, 01:20 AM
Hey Everyone,

My S13 Motor was blown. Someone is selling a 98 S14 Motor. Can I just drop this in my S13? What do I need to change? ECU? Whatelse? I searched but couldn't find anything.

Thanks

Jung918
12-31-2006, 11:33 AM
What you will do is use all the s13 electronics. Just change out the manifolds and the dizzy and you should bet set. You might as well change out the front and rear main seals, water pump, thermostate, tensioners, chains, etc while your engine is out. I would also use the s14 upper intake manifold and the s13 cams on the new motor.

X 350GT X
12-31-2006, 03:46 PM
Thanks.

*msg to short.

Pacman
12-31-2006, 04:49 PM
Just change out the manifolds and the dizzy and you should bet set.

And you WILL be set. Thats all you need. Just remember that when you order engine parts its for a '98 240SX. Valve covers and stuff are different between S13 and S14.

X 350GT X
12-31-2006, 10:34 PM
And you WILL be set. Thats all you need. Just remember that when you order engine parts its for a '98 240SX. Valve covers and stuff are different between S13 and S14.

thanks. appreciate the reply.

Skullavera
01-02-2007, 01:52 PM
you could drop in the 98 KA with the ecu and engine harness with no problem other than splicing about four wires on the engine harness to the s13's body harness. You'd also need to splice wires to the tach, speedo, and temp gauge.

bo2o
08-05-2007, 11:20 PM
sorry to bring back a old thread.

but is it ok to run s14 cams on s13 ecu?
ive changed lower intake mani and running upper intake from s14.
do i need to change ne thing else othere then dizzy and manis?
my car runs like shit. and i fuked with timing for a long ass time!
next thing im going to try is use 300zx filter and walbro pump?
do i need to put the s13 cams or sumthing?