Safc II installation

[alonroz]

Been Searching the net including this site for a detailed manual (preferably with pics) about installing SAFC II on sr20det powered S14 with Z32 MAF...:bite:

Really want to do it on my own,
thanks allot,
Alon

[kuramaya]

DO you have the Manuals?

[yokotas13]

apexi usa website has the manuals under support in the top right

didnt search hard enough i guess

[kuramaya]

I have a write up on here somewhere, but the pics are gone. It's easy:

1. Get the Manuals
2. Disconnect Neg Batt Term
3. Get to the ECU
4. Splice in SAFC II harness to colors and locations identified in the instructions an inch out from the ECU Harness plug at least.
5. Solder you connections and then tape them.
6. Hook up your NEG term again.
7. Turn key to acc postion. Wait for smoke from bad connection a miute or so.
8. Follow setup procedures.
9. Since you have VG30 MAFS, ensure you use the correct IN/OUT settings for your SAFC. I explain this in my Z32 MAFS install thread.
10. Drink Beer and have sex with a fine asian chick that just shaved her snatch.
Late
Daryl

[alonroz]

The only instructions on the Apexi site for wiring are for SAFC I not II,
are they the same?
and daryl. about no.10 ill try to find some asian chick...not too many round here...
thanks allot...

[kuramaya]

Wire diagram should be same for SAFC unless someone can say otherwise.
http://www.apexi-usa.com/pdfWiring/7.pdf

Operators manual, it says Japan on the site but this one is cool
http://www.apexi-usa.com/pdfWiring/1.pdf

[yokotas13]

i used the one from the site to hook up my SAFC2. and it works