Power steering leak!

[FinalDrive]

I just changed the pressure hose on my '93 and I can't get a good seal on the lower flare fitting. The threads were sealed w/ teflon tape, but it squirts red ATF even at idle. Any suggestions?
Thanks in advance

[projectRDM]

Are both crush washers present? Without them it will continue to leak.

[FinalDrive]

Both crush washers are on there where the pressure line bolts to the pump.

Are there crush washers for the flare fitting at the other end of the pressure line? I don't have anything on there other than teflon tape.

[FinalDrive]

Hate to bump, but I still haven't sorted this out
Are there any tricks to getting a better seal on a flare fitting?
It appears to be leaking between the flare nut and its hard line, not the threads

[mrk9182]

if you are talking about where the line bolts to the rack there is a small oring that goes in there make sure they oring didnt get pinched

[FinalDrive]

it appears that the flare end is slightly deformed
new hard line from the high pressure hose to the steering rack was ordered
thanks for the help guys!