PDA

View Full Version : KA24DE Water Pump install.


Ryencool
09-13-2006, 07:11 PM
So I'm about to replace the water pump after installing a new koyo rad last week (go figure the pump goes out the next week). Is there a write up anywhere for this and if not would one be wanted by anyone? Seems pretty straight forward but if anyone has info I might need to know that will help please let me know. Thanks!

projectRDM
09-13-2006, 10:02 PM
1) Remove old pump.
2) Install new pump.
3) Bleed coolant.

If you installed the radiator without issue, you don't need a writeup for the water pump.

Jung918
09-14-2006, 01:08 AM
Take off shroud, fan, fan clutch, then the pump.

sw20>>s14
09-14-2006, 02:26 AM
just make sure to tension the belt within the proper range...

kandyflip445
09-14-2006, 03:33 AM
Or it will go out faster than it should...

Neejay
09-14-2006, 06:55 AM
As already stated:
- Drain coolant
- Remove belts (loosen brackets, etc.)
- Remove fan (4 small bolts)
- Remove water pump (few bolts)

It's easy.