Dizastical
07-19-2006, 02:31 PM
I have a brand new set of SPL Parts subframe / chassis aluminum bushing inserts. They ate the collars that slide into place without having to completely remove the rear subframe. It consist of 4 top collars and 4 bottom collars. All of them are aluminum finish. Here is the description right from SPL.....
Subframe bushing collars takes up slop developed by old rubber or urethane subframe bushings, to yield a more responsive suspension and reduced wheel hop. These 8 piece aluminum collars install above and below the bushings which retains the stock anti-squat geometry, vs. 4 piece spacers that just install on the bottom which slightly increases anti-squat.
Note: top piece is slotted to allow installation without dropping the whole subframe.
Price is $50 shipped.
Paypal to [email protected]
Thanx for looking,
[email protected]
Subframe bushing collars takes up slop developed by old rubber or urethane subframe bushings, to yield a more responsive suspension and reduced wheel hop. These 8 piece aluminum collars install above and below the bushings which retains the stock anti-squat geometry, vs. 4 piece spacers that just install on the bottom which slightly increases anti-squat.
Note: top piece is slotted to allow installation without dropping the whole subframe.
Price is $50 shipped.
Paypal to [email protected]
Thanx for looking,
[email protected]