PDA

View Full Version : Look here and tell me if somethings wrong


koukidough
06-05-2006, 10:47 PM
Okay I am rewiring my harness because sometimes when I touch my mafs wires it stutters. It even stutters intermittently sometimes. I am thinking the culprit could be these amp things thats attached to the end of the maf. I am not sure if its even supposed to belong there cuz I got it that way when I bought my front clip awhile back. I didnt see those on my old ka24de wiring on the maf at all. Well yeah anyway let me know if these are supposed to be here or not and if I should remove them. I have a hunch my car will run smoother with it off but don't know. Thanks!

there are 3 amps, one .85 and the other two is 1.25
http://mysite.verizon.net/res7q23b/mafcable.jpg

http://mysite.verizon.net/res7q23b/mafcable1.jpg

gotta240
06-05-2006, 10:51 PM
those aren't "amp" things... They are wire connectors that just connect one wire to another.

If i were you i would go buy a 10 dollar soldering iron, 4 bucks of solder, and some shrink wrap for wires. Take those ugly, non-conductive things off, and solder the wires together, and shrink-wrap your work...

Will look better, and hopefully function better. just do one at a time so you dont mix em up.

koukidough
06-05-2006, 11:02 PM
haha stupid me I dont know much about wiring but I did wire my s13 sr to s14 myself (was pretty tough regardless what people say). Since they are connectors then that would mean my maf wires werent shielded very well. Good looking out thanks!

gotta240
06-05-2006, 11:18 PM
no prob... With your wiring job, you've done more than me...so no worries.

I just know those things from auto sterios, lol.

infinitexsound
06-05-2006, 11:52 PM
those aren't "amp" things... They are wire connectors that just connect one wire to another.

If i were you i would go buy a 10 dollar soldering iron, 4 bucks of solder, and some shrink wrap for wires. Take those ugly, non-conductive things off, and solder the wires together, and shrink-wrap your work...

Will look better, and hopefully function better. just do one at a time so you dont mix em up.+1 for solder and shrink wrap.... discard those fugly connectors..