gotta240
06-05-2006, 09:07 PM
Ok... I previously inquired about a 95 obd 1 computer and cel. I figured it out, got the codes from the flashing light, cleared the codes, etc. All went well.
NOW i'm working on my 96 obd 2 s14 with the stock ka24de. There is no light in the computer, but i'm pretty sure i'm just supposed to look at the dash light...correct?
Also, turn the screw clockwise, and turn it back... I look at the cel on the dash, and it blinks code 34. KNOCK SENSOR. THEN i turn it BACK to the clockwise position for a few seconds, and then return it to the original position. Isn't this supposed to CLEAR ALL CODES? When i do that, the cel light STAYS ON...no flashes...=good.
BUT, when i go BACK to clockwise, and BACK to counterclockwise again, it reads CODE 34 AGAIN! Shouldn't it have cleared the code,(at least till i start the car again) and flash a 55(clear ecu)???? ANy help would be appriciated...
ps- where is the knock sensor located?
NOW i'm working on my 96 obd 2 s14 with the stock ka24de. There is no light in the computer, but i'm pretty sure i'm just supposed to look at the dash light...correct?
Also, turn the screw clockwise, and turn it back... I look at the cel on the dash, and it blinks code 34. KNOCK SENSOR. THEN i turn it BACK to the clockwise position for a few seconds, and then return it to the original position. Isn't this supposed to CLEAR ALL CODES? When i do that, the cel light STAYS ON...no flashes...=good.
BUT, when i go BACK to clockwise, and BACK to counterclockwise again, it reads CODE 34 AGAIN! Shouldn't it have cleared the code,(at least till i start the car again) and flash a 55(clear ecu)???? ANy help would be appriciated...
ps- where is the knock sensor located?