420hp, stock bottem end???

[KrazyZenki]

I am switching to a new setup. GT3071R, AEM EMS, GReddy stage 2 cams and valvetrain, GM 3 bar MAP, Greddy intake manifold....anyway I expect to see around 420 at 20psi, will there be a problem with the stock SR bottom end holding the power?



I am building a built block on the side but will be running stock block for a few months.

[NemeGuero]

I would think your bearings or pistons would hurt a little from that much boost.

[Shadytrixta1]

Well the record here in Florida is 611HP on a stock bottom end. I guess it would depend on how your gonna drive it.

[statik]

bottom end can handle it depending on condition and assuming a good tune. Headgasket and ARP headstuds are needed for sure.

[EchoOfSilence]

yeah, but for how long?

[Dr.Baby]

i ran a stock bottom end/headgasket motor just had some jun cams at 32 psi for 3 months...track car only and well im not the easiest on cars. motor finally gave out...catch can was full and overflowing and i had rod knock after 2 straight days of drifting. took a beating though.

[KrazyZenki]

well im running cometic hg and arp had studs with previously mentioned mods so you think it will hold up? also 20psi will only be seen during tuning and once a month if I find someone to race where I will actually need that much. For everyday driving it with only see .8bar, roughly 11.5psi.

[Dr.Baby]

honestly i dont think itll be a problem, im a HUGE asshole to my motors anyone who knows me can vouch for this i always drive 110%. but i would definetly have a motor being built on the side when this one DOES blow because IT WILL.