no spark problem

[crashtestdummy]

well i just swaped a 98 dohc into my 90, im using a s13 dohc harness, computer, and intake. everything works, expect im getting no spark. I have power to the coil, the injectors are pulsing (checked with noid lights) all my grounds are hooked up. anybody have any ideas????? this thing is drivin me nuts
thanks

[SiLviAgYrl]

hrmmmm.. anyone know cuz im stuck on it too.

[Markovich]

did you check your timing? and all your wires,

[NIK90s13]

Yea timing is a big issue, you have to be sure it is 100%. Is your distrobutor in at #1 on TDC. If you are sure of your timing, check you distrobutor, cap, rotor.

[crashtestdummy]

yea im pretty shure about the timing, i brought the motor up on tdc #1 cylinder and wired it from there, it has a new cap and rotor too

[Markovich]

was it tdc on exhaust or power?

[crashtestdummy]

im pretty shure it was on power, but i'll check again.

[Markovich]

either put your finger over the spark pulg hold and have a trustwerthy friend just tap the key over until it pushes your thumb off the hole then stop and put it at tdc then. what might be happen is its sparking on every exhaust.. lol hope you firgure it out

peace
~sr20 powered

[crashtestdummy]

hey thanks, i finally figured it out, it was one of those stupid things i didnt tighten the screw allthe way down on the computer harness plug so the four wires in the center that just happen to fire the coil, wernt touchin.lol well thats what i get for trying to stay up all night doing a engine swap =)
thanks again