throwout bearing piece. help.

[meteorite_flo]

there's like this cylinder piece that came off when i took the throwout bearing for my clutch install. it looks all fudged up. i'm wondering what is it called?? anyway i can replace it?
here's the pic:

http://i17.photobucket.com/albums/b100/meteoriteflo/84490799_266722690_0.jpg

[S13 S I L V I A]

Its called the clutch release sleeve.

Part number: 30501-0H600

[meteorite_flo]

it's for a sr20 tranny. is the ka clutch release sleeve the same?

[kouki_s14]

looks like the piece that the TO bearing is pressed into

[meteorite_flo]

ok..i'm really in need of this. but is it possible to install my clutch with this piece all jacked up lookin? i'm working on it as we speak..

[S13 S I L V I A]

it's for a sr20 tranny. is the ka clutch release sleeve the same?

That part number was for a SR20DET.

[S13 S I L V I A]

is the ka clutch release sleeve the same?

It should be but heres the two part numbers listed for the KA24D(E)

30501-K0461
30501-K0401

Alternate 30501-0H600

[S13 S I L V I A]

Im sure its just been revised any of those part numbers should work for.

[meteorite_flo]

thanks silvia you're a great help. i just ordered it at courtesy nissan. and my dumb fuck brother just fuckin finished the install already. now i'm wondering if it's okay to drive with it a release sleeve like that?

[SimpleSexy180]

it might cause issues for u later on. I drove like that and the clutch pedal would get stuck sometimes.