Jeff240sx
06-05-2002, 12:38 AM
Allright, my turbo WILL be installed next Thursday, and I am now looking around for gauges. I found decent ones, but the pods dont seem to work together.
My setup.... I want it to be 2 gauges on the a-pillar. Have a pillar pod in mind. The Autometer one... and it holds 2" gauges or something. Fine.
But then I want 3 in a DIN sized holder. Well... Blitz makes a triple 43mm holder, and HKS makes a triple 46mm holder. Ok. Autometer gauges are standard measurements, in inches. Aside from the fact I want all my gauges to look the same, the damn 43 and 46mm gauges are $300 EACH!!! Blitz is the only maker of 43mm, and HKS the only maker of 46mm. WTF!?! Can I do something and stick standard Autometer gauges into that pod? Does anyone know where I can get standard measurement 3 gauge DIN holder? I'm about to pull my hair out. I have 8 days, and no gauges!!!
-Jeff
My setup.... I want it to be 2 gauges on the a-pillar. Have a pillar pod in mind. The Autometer one... and it holds 2" gauges or something. Fine.
But then I want 3 in a DIN sized holder. Well... Blitz makes a triple 43mm holder, and HKS makes a triple 46mm holder. Ok. Autometer gauges are standard measurements, in inches. Aside from the fact I want all my gauges to look the same, the damn 43 and 46mm gauges are $300 EACH!!! Blitz is the only maker of 43mm, and HKS the only maker of 46mm. WTF!?! Can I do something and stick standard Autometer gauges into that pod? Does anyone know where I can get standard measurement 3 gauge DIN holder? I'm about to pull my hair out. I have 8 days, and no gauges!!!
-Jeff