alarm no start issues

[aznxplayer]

so i was installing some electrical stuff last night, and came across an alarm that was already in the car. i ripped it out, brain and wires, pretty much just traced the wires from the brain, disconnected them, and took it all out. i thought it would be fine cause ive done it before on my old s13s and everything worked fine after i did that.

so i have a push button start, which pretty much just jumps the starter (one cable goes to battery + and other goes to starter power cable) i dont get anything from the button now, no clicks, nothin. (when i tried to start the car with a weak battery before it would just click and shut off the electricity in the car) all the electricals work in the car except for this switch.

everything worked perfect before i started fuckin with it. any suggestions?

[aznpoopy]

did you reconnect the wires after you removed the alarm?

usually an alarm installation involves cutting wires so the alarm can install between em... un-installiation involves tracing them back and reconnecting them.

if you have the alarm brain, look up the brand and model # on google. if you're lucky, you might find DIY installation instructions. uninstallation is the reverse. good luck.

[aznxplayer]

the person who installed the alarm used those wire taps with the spade connectors, i just removed the spade connectors.

[BoNyG515]

the starter switch you have could be bad or a starter kill relay was installed with the alarm. you must find out where that relay is and reconnect the starter wires...good luck man

[NIK90s13]

Check fuses, you may have poped somthing, if you are sure you pulled the alarm properly.