Indolent
04-12-2006, 12:06 AM
http://pic13.picturetrail.com/VOL465/2194199/4280877/138913917.jpg
2/6 injectors say denso, part number is something something 1350, low impedence, you'll need resistors which i don't know about, comes with harness plugs, make an offer for them
http://pic13.picturetrail.com/VOL465/2194199/9239712/131335564.jpg
sr t25 ka24de, ss/xs power t25/t28 manifold shown
http://pic13.picturetrail.com/VOL465/2194199/4280877/138915409.jpg
oil feed shown is ran through the front, but you can run it however you want
These oil lines are new/unused, selling because i dont' want an extra set of lines
those super cool expensive red/blue -10AN fittings
-10AN male steel bung welded so you don't need more adapters than needed
90 degree fitting for less stress on line
function7 oil drain turbo fitting, gasket included
misc adapters for both oil drain and feed
this is all you guys need for your turbo set ups for oil, it's all new and ready to go, rather sell the whole lines complete
PM or email me at [email protected]
2/6 injectors say denso, part number is something something 1350, low impedence, you'll need resistors which i don't know about, comes with harness plugs, make an offer for them
http://pic13.picturetrail.com/VOL465/2194199/9239712/131335564.jpg
sr t25 ka24de, ss/xs power t25/t28 manifold shown
http://pic13.picturetrail.com/VOL465/2194199/4280877/138915409.jpg
oil feed shown is ran through the front, but you can run it however you want
These oil lines are new/unused, selling because i dont' want an extra set of lines
those super cool expensive red/blue -10AN fittings
-10AN male steel bung welded so you don't need more adapters than needed
90 degree fitting for less stress on line
function7 oil drain turbo fitting, gasket included
misc adapters for both oil drain and feed
this is all you guys need for your turbo set ups for oil, it's all new and ready to go, rather sell the whole lines complete
PM or email me at [email protected]