View Full Version : KA24 rebuild
Dat_KA24_Boi
02-27-2006, 05:32 PM
I have a 91 240 cpe sitting in my driveway...The motor runs like ass N i'm wondering if anyone has advice on tearing down the KA juss to rebuild enough to run properly. I'll worry about extra mods later on down the road but if anyone has done it B4 I need some pointers.
jfeldman
01-14-2012, 03:49 PM
I have the book for that motor and I and considering a full rebuild wire harnesses fuses relays distributor cap plug wires alternator harness there's 4 wiring harness is just in the front end of the car there is approximately 78 sensors relays and modules on the ka24 it's hard to diagnose without knowing how the car is running in what it's doing my suggestion is find out how to read the output codes from the computer there is the way to use a paperclip to the computer harness or front wiring harness located underneath the dashboard on the driver side I believe it is mounted behind the radio on the floor somewhere and by putting a paperclip in there in the car is running you let it run for 3 minutes after it warms and park it at x rpm then you turn the car off ignition system offyou insert the paperclip into 1 of the I believe it's 24 pin connectors you bend of the paper clip so that you can insert the other end into another 1 of the terminals I do not know which 2 terminals it is
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.