S14 Kouki cluster into Zenki, ONLY IF U HAVE DONE IT

[Skyline0586]

For those who have successfully done this, was it fairly simple? is there a site that could provide the connecting wires. I have the FSM but i think it would be helpful if someone who has done it could post pictures or somethin for it

[ALTRNTV]

Try the Technical section.

[projectRDM]

I could swear I already answered this.

You don't need an FSM. It helps, but common sense does a damn good job of it.

Lay both clusters face down and look at the printed circuits, there are traces per each pin and it's labeled on nearly all of them what they're for. All the warning lights, etc. Both will have this. Follow it to the plug connection and match it to the pin in the harness. Same with the gauges, the contacts are made with stainless screws, each one marked.

For example, the turn signal indicators are green/yellow and green/black. Just tracing the board from the bulb slot to the plug will tell you that. And as I mentioned before, 95% of the wires match color to color. There is no need for a site or a writeup if you have a brain. I did mine with the FSM over four years ago in less than 10 minutes.

[Siizzzoooo]

so pretty much you need the kouki harness spliced into the zenki wiring...

the harness is the thing i've been searching for

[Dousan_PG]

yeah we went ovre this w/ the same guy i thought? it was pretty clear


i use kouki dash harness w/ zenki rear harness
easy as pie hahaha

but then thats only because my car never came w/ a dash harness.