PDA

View Full Version : Help needed-Z32 Maf installation


vutony
02-11-2006, 03:30 PM
Sigh.....I been tryin to install my Z32 maf for the last 2 hours and no luck doin it...im using the stock z32 harness.....i have tried many combination of wiring and the idle would be unstable and then dies out....i searched and pretty sure this is the correct wiring sequence....

E is 12v power
D is ground for the ecu
C is Chasis ground
B is output signal(white sheilded wire)
D should be one of the sheiled wires too that is black

PS- I have a power fc that runnin on stock map and everythin else is mostly stock.....

ThatGuy
02-11-2006, 03:51 PM
Did you use bjorkluv's write-up in FAQ?

vutony
02-11-2006, 04:05 PM
yea...i did...nuttin

vutony
02-11-2006, 06:02 PM
i think its because i have the power fc....its not tuned and set at stock map cuz i have done any upgrades

anyone know wat i need to set my pfc at??

fliprayzin240sx
02-12-2006, 05:30 AM
Not a whole lot of people keep their MAFs with power fc. Most switch to MAP option...

vutony
02-12-2006, 12:12 PM
yea....thats wat i figured...probally just use the stock one for now and sell the z32

vutony
02-13-2006, 07:52 PM
HOORAY!! got it fixed....it was as simple goin to the commander's settin, airflow, and choose option 4 (VG30)

PS--the wiring was properly connected