PDA

View Full Version : Quick help with part #s, please.


g6civcx
01-29-2006, 09:36 AM
Before you jump on me, yes I actually found the part numbers, and I thought I bookmarked it, but now I can't seem to find it again. The previous did a lot of bad things to the car so I wouldn't trust the parts on here now to be correct, but if I can't figure it out I'll have to use them as sizing on new nuts and bolts. :smash:
****************************************
This is on a redtop SR20DET. I am rebuilding the turbo. I am looking for the Nissan part numbers on the following parts, if possible. Please add your comments if you can help. If I am able to find the link again I'll confirm and post up since most likely a lot of people will have the same question. Thank you.

* Exhaust manifold gaskets and nuts. This is the set of 8 nuts and washers that mount the exhaust manifold to the block via studs. I saw that there were OEM part numbers you can use for these.

* Nuts and gaskets for turbo extension to downpipe. This is a set of 3 nuts and washers. Mine were so rusted you can't even tell if they're 13mm or 14mm. I don't know if there are OEM stuff you can use so I guess I'll have to size them by thread at worst.

Thank you very much if you can help.

g6civcx
01-29-2006, 09:52 AM
Well, I went through the cache and it was posted on NICO. Here are the part numbers when I cross-references with the Nissan parts database:



08912-8401A $0.84
Front suspension - Stabilizer bar and components - Stabilizer link - Lock nut
Lock nut Back 1998 - 1999

14037-42L02 $1.54
YOKE-MANIFOLD

Strange that they listed the nut as a suspension nut, but so long as it works. :) I'll order these and see.

Still no word on the downpipe nuts though.

projectRDM
01-29-2006, 11:08 AM
Endlink nut is a locking type, M12. Same as used on the manifold.

g6civcx
01-29-2006, 02:21 PM
Thanks for the help.